Reading Values from a Temperature Sensor.

Oh it's July !!!

To get temperature and humidity reading from the sensor, our code will perform the following opertions.

Triggers the slave.
Waits for it to be idle.
Reads data to the buffer.
Reads 20 bit raw humidity data and returns relative humidity.
Same are the steps for Tempereature reading too.

Note: I2C Protocol is used for communication between master and slave.

All these steps are implemented in just few lines of driver code.

fn main() {
    let sensor = AHT10::new(&mut AHT10::get());

    loop {
        // Get relative humidity.
        sensor.relative_humidity();

        // Get temperature
        sensor.temperature();

        // Waiting for 2 seconds.
        rustduino::delay::delay_ms(2000);
    }
} // Getting temperature and relative humidity at 2 second interval